User:Vincecate/GeodesicVessel

Idea is that both a hull and roof could be 1/8th sphere geodesic domes. This would sort of be a thick flying saucer shape. With a size of 80 foot diameter we could have two levels inside the saucer and then a small building on top for when people wanted to enjoy the view. The living area might be 50 foot diameter with storage closets and emergency flotation foam in the thinner part around the living area.

The geodesic shape should mean you don't need as much, or maybe any, internal bracing. This can open up the inside space and make it cheaper to build.

The triangles and stiffeners would be easy things for regular shipyard robots to make. So this can be automated and done for a reasonable price.

Might make the triangles so that they could be bolted together. Bolting together could be done near the launch site by a small group with a crane in a few days. This would not be very costly. Might even ship the parts to another country before assembling. Could make it where we put a rubber gasket around each triangle and then bolted them together. The bolts would be put through stiffeners at the edges and completely inside. As they tightened the rubber would make the joint water tight even if there were some slight imperfections in the sizes of the triangles.

Might also just weld the triangles together like sections on a normal ship.

The triangles could be steel or maybe aluminum.

Should be very strong, very stable, very safe, and not very costly for the amount of living space.

In a raft that is rocking back and forth in the waves the center has the least motion. In this design the people are closer to the center.

Windows would only be easy on the small building on top. Might use small strong glass to make portals to let some light in and let people see out some.

The heavy things like batteries should be at the very bottom of the inside space (say below the bottom floor). The building on top should be light so that even if the main hull flooded it would still stay upright.

Steel plate at an angle makes for good armor. If the foam inside is squeezed it can even expand to fill any holes. If this has enough foam that it can not sink, pirates in a smaller sinkable boat would think twice before starting a fight (assuming they were detected).

Requirements Analysis

• Safety
  • It is very wide compared to boats and so should be very stable
  • Part is filled with foam so essentially unsinkable
  • No active ballast controls so no chance of that going wrong

• Comfort
  • Should have a gentle motion on normal days but significant response to large waves.

• Cost
  • This should be one of the cheapest designs. It's very simple. It is as wide as some very large ships.

• Pretty
  • Looks interesting.

• Modular
  • Can make individual family sized units. Could have cable under a line of these so they floated together if you connected a sea anchor at one end and a large kite at the other.

• Cargo
  • Since it floats up and down with waves like a boat, should be reasonable to dock a boat next to it.

• Free Floating
  • Yes, could anchor also.

• Scalable
  • Is small enough for one family.

• Standards

• Mobile
  • Will move through the water easier than most seastead designs but not as easy as a ship.

• Draft
  • Very shallow draft for a seastead.